UNI-T UT804 Specifications download pdf (Page 47)

Model UT804: OPERATING MANUAL

Introduction

Chapter 4 shows you how to use stores, recall and

communication features available on the Meter

Store and Clearing Readings

To store readings, proceed as follows:

Press STORE once, “STORE” and “No.xxxx”

appears to confirm the operation and the upper right

secondary display shows the current measurement

reading. Press

to toggle between clearing the

stored readings and start from the first readings or

start from the last stored reading. Lower right

secondary display shows the original number of

records.

Press STORE the second time, “STORE” and “s”

appears. The upper right secondary display shows

the storing time interval in second, it is preset to

zero which means it will not auto update reading.

To change the interval in second by pressing + or

Press STORE the third time, “STORE” and “No.

9999” appears. The upper right secondary display

shows the index number increase one. The lower

right secondary display shows the value of the

corresponding index number, the primary display

shows the current measurement reading.

If there is no set time to store the reading, each

press of STORE to store one reading. An index

number increase one.

The maximum number of stored reading is 9999.

When the stored readings memory is full, the Meter

will stop storing data.

To exit and stored the reading, press EXIT.

To exit without storing the reading, turn the Meter

off directly.

Automatic power off feature will be disabled after

entering this mode.

Chapter 4

Using Store, Recall & Send Features

- button. The interval can be as high as 255 seconds

or as low as 0 second. Press and hold + or - to

access the quick setting.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 68 69

No comments

UNI-T UT804 Specifications Page 47